Reconstitution Instructions
Reconstituting a peptide means dissolving a freeze-dried (lyophilized) peptide in
a solvent to create a usable solution. This must be done carefully to preserve the peptide’s stability.
Gather supplies:
✅ Lyophilized (freeze dried) peptide.
✅ Bacteriostatic water (or other).
✅ Sterile syringe/needle.
✅ Alcohol wipes for sterilization.
Calculate solvent volume:
Sterilize:
✅ Clean the vial and syringe with alcohol wipes.
✅ Work in a clean environment to avoid contamination.
Add bacteriostatic water:
Draw the calculated bacteriostatic water volume into the syringe.
Slowly inject it along the vial’s inner wall to avoid disturbing the peptide (the vial will be at a negative pressure,
so it will want to draw the bacteriostatic water in, be prepared to slow down the injection into the vial with pressure against the plunger).
Gently roll the vial (don’t shake) to dissolve. Let it sit if needed.
Store properly:
✅Store at 2°C and 4°C and away from sunlight.
Key tips:
✅ Peptide Care: Avoid shaking or excessive heat. Some peptides need specific conditions (e.g., pH or reducing agents).
✅ Dosage: After reconstitution, calculate doses based on concentration. Example: For a 2 mg/mL solution, 0.1 mL = 200 µg.
✅ Safety: Research peptides are not for human use.
Always consult with a healthcare professional for personalized guidance and training before performing injections.
Peptide Pen Instructions
Administering an injection requires careful preparation and technique to ensure safety and effectiveness.
Below are step-by-step instructions for giving an injection using a peptide pen.
Gather supplies:
✅ Injection pen with the correct cartridge.
✅ Pen needle (new, sterile).
✅ Alcohol wipes or swabs.
✅ Sharps container.
Wash your hands:
✅Wash and dry your hands thoroughly.
Prepare the peptide pen:
✅ Check the cartridge in the pen to confirm it’s the correct type.
✅ Wipe the pen’s rubber tip with an alcohol wipe.
✅ Attach a new pen needle by screwing it onto the pen securely.
Prime the pen:
Set the pen to a low dose (e.g., number 2 on the dial).
Hold the pen with the needle pointing up and press the injection button to release a small amount of liquid.
Check for a drop of fluid that appears at the needle tip. Repeat if nothing appears (this ensures the pen is working and air is removed).
Set the dose:
✅ Dial the pen to the desired dose (e.g. number 10 on the dial).
Choose an injection site:
✅ Select a site.
✅ Rotate sites to prevent tissue damage.
✅ Clean the site with an alcohol wipe and let it dry.
Administer the injection:
✅ Pinch a fold of skin (about 1–2 inches) for better accuracy.
✅ Insert the needle at a 90-degree angle (or 45-degrees if necessary).
✅ Press the injection button fully and hold it for 5–10 seconds to ensure the full dose is delivered.
Remove the needle and dispose:
✅ Pull the needle out and release the skin.
✅ Apply gentle pressure with a cotton ball if needed.
✅ Remove the pen needle and dispose of it in a sharps container. Do not reuse needles.
Record the dose:
✅ Log the dose, time, and site if advised by your healthcare provider.
Always consult with a healthcare professional for personalized guidance and training before performing injections.